Firewall requirements for Sage 50 Accounts
Description

The Sage 50 Accounts Data Service runs on the computer or server which holds your Sage 50 Accounts data. The service acts as a gateway and controls the reading and writing of data.

If you require further help with this you may need to contact your IT administrator.

Cause
Resolution

Check which firewall you're using

If you're  not sure which antivirus or firewall software you use, you can check by using the following options:

  • If you're using Sage 50 Accounts, open Help > About and from the System Details section, check the Firewall details.
  • Start > All programs > look for anti-virus or firewall software in the list.
  • Start > Settings > Control Panel > look for any antivirus or firewall software.
  • Start > Run > enter services.msc >  OK > look for anti-virus/firewall software in the Services list.
  • Use the mouse to hover over the system tray The system tray is normally found in the bottom right corner of your screen, next to the clock. Each option you hover over shows the name of the application that is running. Look for any antivirus or firewall software.

To ensure that your firewall doesn't block the Sage Data Service, please ensure the following ports are open - 

You can configure the ports for specific IP addresses. On the server, you can add the IP addresses for the client computers to the inbound rule for the port. On the client computers you can add the IP address for the server to the outbound rule for the port. Naturally, this can't apply if you use dynamic IP addresses.


Further help

Support pages for some of the more popular antivirus and firewall software on the market -

[BCB:19:UK - Sales message :ECB]

 

Steps to duplicate
Related Solutions